JP low-voltage integrated distribution box shall comply with IEC439-1 "Low-voltage switchgear and control equipment", GB7251.12-2013 "Low-voltage switchgear and control equipment Part 2: Complete power switch and control equipment", GB/T15576- 2008 "Low-Voltage Complete Reactive Power Compensation Device" related standard requirements.
Service environment
1. Air temperature: -25℃---+40℃
2. Humidity: Monthly average humidity 95%; Daily average humidity 90%.
3. Altitude: ≤ 2500m
4. Ambient air not apparently polluted by corrosive and flammable gas, vapor, etc.
5. No frequent violent shake
Installation requirements
1. The switchboard (box) should be made of non-combustible materials;
2. In production sites and offices with low risk of electric shock, open-type power distribution boards can be installed;
3. Closed cabinets should be installed in processing workshops, casting, forging, heat treatment, boiler rooms, wood workshops and other places where the risk of electric shock is high or the working environment is poor;
4. Airtight or explosion-proof electrical facilities must be installed in hazardous workplaces with conductive dust or flammable and explosive gases;
5. The electrical components, meters, switches and circuits of the distribution board (box) should be neatly arranged, firmly installed and easy to operate. The bottom surface of the floor-mounted board (box) should be 5~10 mm above the ground;
6. The center height of the operating handle is generally 1.2～1.5m; there is no obstacle within the range of 0.8～1.2m in front of the board (box);
7. The connection of the protection wire is reliable; no bare live body shall be exposed outside the board (box);
8. The electrical components that must be installed on the outer surface of the board (box) or on the distribution board must have reliable shielding
Main Parameter
| NO. | Description | Unit | Parameter |
| 1 | Rated voltage | V | 400 |
| 2 | Rated frequency | HZ | 50 |
| 3 | Capacity | KVA | 30 50 63 80 100 125 160 200 250 315 400 500 630 |
| 4 | Capacitor grouping | | 2 3 4 5 levels (according to user requirements ) |
| 5 | Bus bar Rating | A | 630 |
| 6 | The metal used for busbars | | Copper |
| 7 | Type of protection used on busbars against corrosion (e.g. heavily tinned) | | Tinned Plating |
| 8 | Dimens ions of busbars (length x width x thickness) | mm | 660 x 50x 5 |
| 9 | Method of connection between busbars and cable lugs (cable lugs not to be provided) | | Bolted Typ e |
| 10 | Fixing center of HRC fuse | mm | 90 |
| 11 | Ar e-safety barriers fitted between phases of the same incoming or outgoing unit? | | Yes |
| 12 | Are insulating shields fitted between adjacent units? | | No |
| 13 | Minimum clearance between the lowes t cable connection and ground level | mm | 300 |
| 14 | Material used for housing | | Ho t Dipped Galvanized Sheet |
| 15 | Treatment of housing against atmospheric corrosion | | 7 Tank Process |
| 16 | Padlocking facility on housing door | | Yes |
